We are working on getting the Nebra Indoor Hotspot certified in multiple regions. As we have results from the certification process we will post them here.
|Approval||Countries Covered||Hardware Frequency||Status||Frequency Plans|
|CE||European Economic Area||868 Mhz||Completed||EU 868|
|UKCA||United Kingdom||868 Mhz||Completed||EU 868|
|FCC||United States of America||915 Mhz||Completed||US 915|
|ISED||Canada||915 Mhz||In Progress||US 915|
|RCM||Australia & New Zealand||915 Mhz||Completed||AU 915|
|MIC||Japan||915 Mhz||In Progress||AS 923-1|
|SRRC||China||470 Mhz||In Progress||CN 470|
|EAC||Russia||868 Mhz||In Progress||RU 864|
|WPC||India||868 Mhz||In Progress||IN 865|
All certification-related documents can be viewed in the certification folder for our indoor miner.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.